|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The Service Manual was just as expected, complete with schematics and I was able to download it in less than an hour after I ordered it. The only problem with these is that the schematics are hard to read due to the small font. I could remedy this by printing them on a larger printer.
 ;
Very fast, clear and usefull site !
Also this Service Manual are very well maked and with a very good definition !
Very fast download speed !
Recomended Seller !
;
The manual you sent me was excellent. It included clear, readable diagrams and a usable parts list. I would surely use your service again. Thanks
;
Payments were processed quickly and items were exactly as described. I will use owner-manuals.com in the future for any other manual needs.
;
The Technics manual was very clear and I was able to solve my technical problems.
I did not think that anyone kept these manuals and was pleasantly surprised to find them on the Internet and at an affordable price.
I would recommend Owner Manuals as a first source of technical products for ‘dated’ equipment manuals.
Ian
PIN No.
SYMBOL
PIN NAME
DESCRIPTION Device ground pins. Remarks: Pins 26 and 58 are connected inside the chips, and therefore it is not necessary to use both pins for GND: One of them is used for GND. Beep output pin when momentary key pressed. A 2.25 kHz and 50% duty square wave is output for approx. 40 ms. This time is equal to the premuting time. When a momentary key is pressed and the state of the LCD panel display or output port is changed (valid key) and at the end of 5 seconds hold during preset memory scan and scan operations, a beep is output. To disable the beep, float (leave open) this pin. The beep output is also used at SK alarm at DK standby.
OUTPUT TYPE
26 GND 58 Ground
�
27
BEEP
Beep output
CMOS push-pull
28 to 39 40 to 55
LCD27 to LCD16
LCD15/KS15 to LCD0/KS0
LCD panel segment signal output (pins 28 to 55) and key matrix key source signal output (pins 40 to 55) pins. 56-dot display is performed at the LCD panel by matrix with LCD segment the COM1 pin (pin 56) and COM2 pin (pin 57). and Since LCD15/KS15 (pin 40) to LCD0/KS0 (pin 55) share the key key source source signal and LCD segment signal, to use them as key output source signals, a reverse current prevention diode is necessary. For the connection method, see 1.3 �Key Matrix Connection� and 6 �Application Circuits�. Common signal output to LCD panel. 56-dot display is performed at the LCD panel by matrix with LCD27 (pin 18) to LCD0/KS0 (pin 55).
CMOS push-pull
56 57
COM1 COM2
LCD common signal output
CMOS push-pull
59 to 62
K3 to K0
Key return signal input
Key matrix key return signal input pin. Since the key source signal output is shared with the LCD segment signal, do not connect a pull-down resistor to this pin.
Input
16
|
|
|
> |
|
