|
Who's Online
There currently are 5850 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Great manual very clear copied. You are making an incredible job. I appreciate a lot the rapidity and your efficiency. Thanks a lot
;
Good pdf of the service manual for this unit. Includes disassembly instructions, full schematics, board layouts, parts lists and diagnostic information. Some information is in the pdf twice (single pages, and split pages), but that could be how it was originally generated by panasonic, or perhaps the idea is to make it eaiser to put onto 8.5 x 11" pages.
Information was exactly what I needed. Delivery was overnight (less than 12 hours) and I was happy with the process.
;
5 STARS for FAST DELIVERY, BEST PRICES and QUALITY PRODUCT. Item was exactly as described with superb resolution. Will definitely source all my future requirements from this website. Thanks a lot owner-manual.com!
;
OEM manual provided all schematics, board layouts and component specs necessary to facilitate unit maintenance. All pages were clear and readable.
;
Good condition and quality. Hard to find anywhere in Internet, only on this site.
ADJUSTMENTS
TAPE ALIGNMENT CHART Step Item Reference Value Test Tape Adjust Point Test Point Note Be sure Wow & Flutter is within 0.35% Adjust Tape Speed of end position after adjustment at tape start position Be sure High speed after normal speed adjustment FIG.
Normal 1 Tape Speed Adjustment High 2 3 Azimuth Adjustment Recording Bias Oscillator Frequency Adjustment
3,000~3,010Hz
MTT-111N
RV601
Line Out L/R Channel
FIG.1
5,820~6,180Hz Maximum Level Phase:Within90° 80 KHz±0.5
MTT-111N MTT-114N MTT-5511
-----Head Screw L601
Shorted TP601, TP602 Line Out L/R Channel CM617,GND
FIG.1 FIG.2,3,4
Adjust with frequency counter connected.
FIG.1
Adjust with Frequency Counter Connected Test Tape : MTT-111N(3kHz) MTT-5511(Blank) Set Output Level Measurement Point Forward Side Reverse Side Frequency Counter
FIG. 1 : Tape Speed & Record Bias Oscillator Frequency Adjust Circuit
FIG. 2 : Tape Azimuth Adjust Location (Record/Playback Head)
L-CH Peak
Test Tape MTT-114N (10kHz)
L-CH
Oscilloscope
within 1 dB Output Level R-CH Peak within 1 dB
Set
V
H
Screw Angle
Output Level Measurement Point Screen Pattern
L-CH Peak
R-CH Peak
Screw Angle
In Phase 45 Good
90
135
180
Wrong
FIG. 3 : Tape Azimuth Adjust Head Screw & Waveform
FIG. 4 : Tape Azimuth Adjust Circuit & Waveform
6
|
|
|
> |
|