This is a great site. I placed my order and by the next am it was available for download. Had some problems with some missing copy on some pages. Once I brought the error to the OMC's attention, the issue was resolved. I'll come back again.
The quality of this manual is good. It has all schematics and setup information for both the MDS-B3 and the MDS-B4. The scan quality is quite good, all pages are readable, This service manual also contains scans of the operating instructions from the User manual.
Das Service Manual war von der ersten bis zur letzten Seite sehr informativ und hilfreich. Die Darstellung aller Teile war klar und der Text gut lesbar.
Vielen Dank, das war nicht der letzte Download bei ownner-manuals.com.
Text excerpt from page 39 (click to view)
PIN NAME DIG.VDD
FUNCTION A Vdd terminal for of digital block. Supply HVcc voltage through 270 ohms of resistance. The voltage of this terminal is clipped to approximately 3.3V by the internal regulator.
An input terminal for Sync signal. The input sync tip is clamped by charging/discharging the coupling capacitors so as to align the Sync slice level. Input is through a low impedance buffer, (input level 1Vp-p/140IRE)
An input terminal for Y signal. The pedestal level is clamped by means of charging/discharging the coupling capacitor, therefore input through low impedance buffer. (1Vp-p/140IRE input level)
39 1k 1k 1k
A terminal to be connected wiht a capacitor to detect the average picture level for DC restoration. The ratio of the DC restoration is set by bus. Leave this terminal open if the DC restoration is not required.