This document is just what I was looking for, it´s very useful, it contains adjustment procedures for the final stage of the power amp and also
has a complete wiring diagram and description of the main semiconductors used in the design.
Dear Sirs,
Thank you for the fast support, the manual does provide all necessary information to repair the radio. All schematics are in a good quality for reading.
The manual fits 100% to my requirements as a technican.
Kind regards Thomas
Text excerpt from page 39 (click to view)
APPENDIX
IC DESCRIPTION
37
PIN NAME DIG.VDD
FUNCTION A Vdd terminal for of digital block. Supply HVcc voltage through 270 ohms of resistance. The voltage of this terminal is clipped to approximately 3.3V by the internal regulator.
31 37
INTERFACE
H VCC
30
30
2.6V
30
750
38
SYNC IN
An input terminal for Sync signal. The input sync tip is clamped by charging/discharging the coupling capacitors so as to align the Sync slice level. Input is through a low impedance buffer, (input level 1Vp-p/140IRE)
31
38 1k
33
39
Y IN
An input terminal for Y signal. The pedestal level is clamped by means of charging/discharging the coupling capacitor, therefore input through low impedance buffer. (1Vp-p/140IRE input level)
39 1k 1k 1k
42
19
40
DC RESTOR
A terminal to be connected wiht a capacitor to detect the average picture level for DC restoration. The ratio of the DC restoration is set by bus. Leave this terminal open if the DC restoration is not required.