|
Who's Online
There currently are 5903 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Very complete and well reading drawings. Documentation is essential for successful repairs.Good documentation, with all that is necessary. This manual was what I was waiting with all the information necessary for the repairing I need it for. You must buy it if you want to do repairs or simply understand how it works.
;
Excellent service manual includes everything is need to repair this radio-caseete, how to disassemble, wiring diagram, all , waiting time until the download was only a few hours. I'm going to buy service manuals from here, are cheap and very good.Thank you.
;
Good service manual,i saved from scrapping this deck,is now fully functional.Thanks.
;
Found this to be the manual included with the original packinging, was helpfull but did not give any detailed repair instructions.
;
Complete service manual, was very helpful in repairing this tapedeck.Thanks.
2. SCREEN
1) Receive the Retma pattern and heat run over 15 minutes. 2) Adjust the �R, G BIAS, R, G DRIVE� to 0, �B BIAS� to 127, �B DRIVE� to 32. Adjust the screen volume that the Retma pattern reach to the cut-off point.
3. WHITE BALANCE
1) Receive the Full white pattern and heat run over 15 minutes. 2) Adjust the picture control at the point �Y� value of white balance instrument in 20cd/. 3) Enter the service mode. 4) Adjust �R BIAS, G BIAS� to x=288, y=301. 5) In order to exit the service mode power off the TV set and power on. 6) Set the TV set to �Normal I� mode(20/21 inch) or set to �Normal II� mode(14 inch) 7) Enter the service mode. 8) Adjust �R DRIVE, G DRIVE� to x=288, y=301. 9) Repeat above process until the white balance value to x=288, y=301, Y=20, x=288, y=301, Y=200(approximate) in 2) � 8).
4. FOCUS
1) Apply a RETMA PATTERN signal. 2) Adjust the Focus Volume on FBT to obtain optimal resolution.
5. AGC
1) Set the pattern Generator with RF LEVEL = 60dBuV 100% FULL COLOR BAR 2) Connect the pattern generator RF output to tuner RF input. 3) Connect the probe of oscilloscope in AGC pin of tuner. 4) Adjust the AGC point to MAX � 1V. (Simple Method) 1) Receive the pattern. 2) Locate the cursor in �AGC� and adjust using the �VOL +� or �VOL �� keys. 3) Adjust the point there is no noise in about 60dBuV and no beat in about 90dBuV.
|
|
|
> |
|