|
Who's Online
There currently are 5724 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
I found the manual to be clear concise and complete. It was of immense assistance when removing the unit as the unit was over 22 years old and the wiring diagram was unobtainable from the manufacturer. The exploded drawings were clear as were the instructions and labels.
;
I will highly recommend this seller. They are honest, accurate, fast and responsible.
;
This manual was very good & was very helpful with repairs.
Always great & fast service from Owner's manual.
;
Very pleased with the quality of the scan. No complaints whatsoever.
;
I liked the product. I would use their sevices again.
INTERLOCK MECHANISM AND ADJUSTMENT
The door lock m echanism is a device which has been specially designed to com pletely elim inate m icrowave radiation when the door is opened during operation, and thus to perfectly prevent the danger resulting from the leakage of microwave.
(1) Prim ary interlock switch W hen the door is closed, the hook locks the oven door. If the door is not closed properly, the oven will not operate. W hen the door is closed, the hook pushes the button of the m icroswitch. Then the button of the primary interlock switch bring it under ON condition. (2) Secondary interlock switch and interlock m onitor switch W hen the door is closed, the hook pushes the lock lever downward. The lock lever presses the button of the interlock m onitor switch to bring it under NO condition and presses the button of the secondary interlock switch to bring it under ON condition.
ADJUSTMENT
Interlock m onitor switch W hen the door is closed, the interlock m onitor sw itch should be changed(NO condition) before other switches are closed. W hen the door is opened, the interlock m onitor sw itch should be changed(NC condition) after other switches are opened.
(3) Adjustm ent steps a) Loosen the one m ounting screw. b) Adjust interlock switch assem bly position. c) M ake sure that lock lever m oves sm oothly after adjustm ent is com pleted. d) Tighten com pletely one m ounting screw.
NOTE
M icrow ave em ission test should be perform ed after adjusting interlock m echanism . If the m icrow ave em ission exceed 4m W /cm 2 , readjust interlock m echanism .
|
|
|
> |
|